Configuring The Channel Operational Message - Siemens SINUMERIK 840D sl Commissioning Manual

10.4

Configuring the channel operational message

Overview
The channel operational messages are displayed in the third line of the header in the
"Machine" operating area. There are two types of channel operational messages:
1. Channel operational messages that require an operator action to continue a program,
2. Channel operational messages that do not require an operator action to continue a
File
The settings for this are specified in the "slmahdconfig.ini" file.
This file is located on the CompactFlash card in the Siemens/sinumerik/hmi/cfg directory.
Configuring the channel operational message
Section
CondStopIcons
CondDelayTime
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
e.g. feed enable missing, M01 active.
The channel operational messages are identified by exclamation marks.
program. A stop condition is active for a length of time (>1 s) and is interrupted by the
program processing, e.g. dwell time active, waiting for tool change.
The channel operational message is identified by a clock icon and disappears after a
certain time.
Meaning
Specification of an icon that is to be displayed with a certain channel operational
message.
If no icon is specified for a certain channel operational message, then the icon
specified for "DefaultIcon" is displayed.
Specification of how long (in milliseconds) a certain message must be present
before it is displayed.
If no time is specified for a certain channel operational message, then the
•
time specified at "CondDelayTime" is used.
If the channel operational message is to be displayed immediately, "0" must
•
be specified as time.
Customizing the "Machine" operating area
10.4 Configuring the channel operational message
65