Siemens SINUMERIK 840D sl Commissioning Manual page 97

Content_identifier
MagPlaceStateOccupiedUpper
MagPlaceStateOccupiedDown
MagPlaceStateReservedLeft
MagPlaceStateReservedRight
MagPlaceStateReservedUpper
MagPlaceStateReservedDown
MagPlaceMagazineNo
MagPlaceTypeIdx
MagPlaceWearGroup
MagPlaceAdaptNo
MagPlaceNo
MagNoMagPlaceNo
MagPlaceUser_1,
MagPlaceUser_10
MagPlaceAppl_1,
MagPlaceAppl_10
13.4 Configure the list parameters
In the <PARAMETERCONFIGURATION> tag, you have the following options:
1. Change list parameters
2. Create a new list parameter based on an existing list parameter
Change list parameters
You can change all the parameters included in the system apart from the ISO parameters.
Tool parameter identifiers (Page 87)
Cutting parameter identifiers (Page 88)
Monitoring parameter identifiers (Page 90)
Magazine location parameter identifiers (Page 90)
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
Parameter or property
Magazine location occupied, upper half location
Magazine location occupied, lower half location
Magazine location reserved, left half location
Magazine location reserved, right half location
Magazine location reserved, upper half location
Magazine location reserved, lower half location
Magazine number
Type index
Wear group number
Adapter number
Magazine location number
Magazine number/Magazine location number
OEM magazine location parameter 1, to
OEM magazine location parameter 10
Siemens magazine location parameter 1, to
Siemens magazine location parameter 10
Configuring tool management
13.4 Configure the list parameters
91