Siemens SINUMERIK 840D sl Commissioning Manual page 99

Example
Only enter the modified data.
Configuring new list parameters based on an existing list parameter.
Assign a new parameter name and enter only the changed data:
Entries
Base
1. Example
2. Example
Entries
Base
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
Meaning
Assign new parameter name
See first example: "NewGeoRadius" text.
Name of the parameter on which the new parameter is based.
See first example: "GeoRadius" parameter is used as a template.
Also enter only the changed data here. All other data is taken from the existing
parameter.
See first example: Column width changed to 46 pixels. Number of decimal
places changed to 1.
Meaning
Assign new cutting edge parameter name
The name is "EdgeUser_1_Bit0" in the following example.
Name of the parameter on which the new parameter is based.
In the following example, the "EdgeUser_1" parameter is used as template.
Also enter only the changed data here. All other data is taken from the existing
cutting edge parameter.
Configuring tool management
13.4 Configure the list parameters
93