This Is How You Restore Data From The Network Drive - Siemens SINUMERIK 840D sl Commissioning Manual

Backing up and Restoring Data
2.3 Data backup on network drive
Scenario II: Start the Command Shell with WinSCP on the PG:
1. Start WinSCP and enter the following data in the log-on window:
2. Select in the menu "Commands" → "Open Terminal".
3. Execute the data backup using the commands described in steps 4 to 6 from scenario I.
See also
Connect (Page 27)
Save (Page 34)
2.3.2

This is how you restore data from the network drive

Sequence
Proceed as follows:
● Stop all subsystems
● Establish a connection to a network drive
● Define a MOUNTPOINT
● Restore the data
● Start all subsystems again
Scenario I: Start Command Shell under Linux
1. Before you can restore backup files, you need to stop the subsystems, e.g. NCK.
2. Switch to the VNC Starter using the key combination <Recall+MENU SELECT> (area
switchover key) or <F9+F10>: A list of VNC connections that can be selected is
displayed.
3. Start a service shell by using the assigned softkey to select "Session 4". In "Session 5",
the log console is output.
4. Log on as a service technician using the user name "manufact" and password
"SUNRISE".
5. Use the command "sc connect" to connect the network drive:
18
Result:
A backup file of the complete CF card is created under the specified path on the network
drive.
– IP address of the NCU (or, if required, host name)
– User name "manufact" with password "SUNRISE".
sc stop all
sc connect //username%password@server/share /tmp/backup
NCU Operating System (IM7)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0