Displaying The Service Overview - Siemens SINUMERIK 840D sl Commissioning Manual

Service and diagnostics

16.2 Displaying the Service overview

16.2 Displaying the Service overview
The status of each machine axis is displayed in the "Service Overview" window.
Information for up to 31 machine axes can be displayed. A column for each available axis is
created for this purpose.
Status displays
Display icon
-
#
Enable displays
Drive enable (terminal 64/63)
Pulse enable (terminal 64/48)
Pulse enable (term. 663 / SI: drive relay)
Setup mode (terminal 112)
PLC pulse enable
Speed controller enable NC
DC link status
Enable pulses
Drive ready
Heatsink temperature warning
Power section in i2t limitation
Motor temperature warning
Measuring system 1 active
Measuring system 2 active
Procedure
158
Meaning
Green The axis is behaving normally.
Yellow The axis is not ready.
Red An alarm is pending for this axis.
Gray The axis is not affected.
Dash No drive assigned to axis.
Special Error when reading the data, e.g. if data is not available.
characters
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
HMI sl (IM9)