Advertisement
Parameter function：Use when testing and no load is connected.
◎P3-05
Soft start acceleration time
Initial value：0
Control mode：3,4,7
Unit：1ms
Setting range：0~65535
Modify effective time："○"can modify when servo OFF，and take effective by servo ON
Parameter function：Setting the appropriate acceleration time can prevent motor shake caused by
excessive acceleration, but note that setting value too large will affect the system response time.
◎P3-06
Soft start deceleration time
Initial value： 0
Control mode：3，4,7
Unit：1ms
Setting range：0~65535
Modify effective time："○"can modify when servo OFF，and take effective by servo ON
Parameter function：Setting the appropriate deceleration time can prevent motor shake caused by
excessive deceleration, but note that setting value too large will affect the system response time.
◎P3-07
Speed command filter time parameter
Initial value：0
Control mode：3,4,5,6,7
Unit：0.01ms
Setting range：0~65535
Modify effective time："○"can modify when servo OFF，and take effective by servo ON
Parameter function: The speed command input is through the primary delay filter to smooth the
speed command. If the setting value is too large,will reduce responsiveness.
◎P3-08
Speed feedback filter time parameter
Initial value：20
Control mode：3,4,5,6,7
Unit：0.01ms
Setting range：0~65535
Modify effective time："○"can modify when servo OFF，and take effective by servo ON
Parameter function：Smoothing the feedback of the speed. If the setting value is too large, the
speed feedback will be distorted, which will affect the control effect.
◎P3-09
Maximum operating speed
Initial value：4000
Control mode：ALL
Unit：rpm
Setting range：0~5000
Modify effective time："○"can modify when servo OFF，and take effective by servo ON
64
0X0305
0X0306
0X0307
0X0308
0X0309
Advertisement
