Advertisement
Do not make the main circuit cables and input and output signal cables / encoder
cables use the same tube, do not put their banding together. When wiring the main
circuit cable input and output signal cables should leave 30 cm or more.
Please use the signal cable to input and output ,and the encoder cables use
twisted-pair wire or suspicious double strand angle and the overall shield.
Input and output signal wiring cable length: maximum of 3 m.Encoder cable:
maximum of 20 m.
Even if power is turned off, servo unit internal may still remain high
voltage.Therefore, during the period of operation instructions (RUN) lights, do not
touch the power supply terminals
Please confirm operation instructions (RUN) in the lamp out, such as further
connection and check the homework
For main circuit wiring terminal row, please observe the following precautions.
When main circuit terminals is the switch, please remove servo unit from the subject
,then wiring
Please within the terminal row of a wire connector socket insert 1 wire. When
inserted into the wire, please do not make the core of burr and the adjacent wire short
circuit.
Please use the specified power supply voltage. Otherwise it will cause fire or failure.
In the case of a bad power supply, when using it, please ensure that the specified
input voltage change within the scope of supply power. Otherwise it will cause
damage to the machine
Please set the circuit breaker and other safety devices to prevent external wiring
short circuit. Otherwise it will cause a fire.
When used in the following places, please take the appropriate measures.
When electrostatic cause the interference
The place where produce a strong electric field or magnetic field.
There may be have the place where have the radiation.
The place where has power cord nearby.
Otherwise it will cause damage to the machine.
When you connect the battery, please pay attention to the polarity. Otherwise cause
the battery, servo unit and servo motor damage and explosion.
Please wiring or check the homework by professional and technical personnel
Advertisement
