Table of Contents
Advertisement
TIENet™ 360 LaserFlow Ex™
Velocity Sensor
Section 4 Setup with 2160 LaserFlow Module
4.1 Activating Connected
Sensors
Figure 4-1 Activate connected sensors in Flowlink
The LaserFlow Ex sensor is compatible with both the Teledyne
ISCO 2160 LaserFlow Module and the Teledyne ISCO Signature
flowmeter. For Signature setup instructions, refer to Section 3.
The 2160 module is programmed and set up using Teledyne
ISCO Flowlink® software. This section of the manual describes
activation of connected sensors, and basic LaserFlow Ex.
This section of the manual assumes the 2160 site is already con-
figured in Flowlink, and the 2160 module is connected to
Flowlink. Detailed Flowlink instructions are available in the
Flowlink Windows Help and also in the Flowlink software user
manual. For complete information about the 2160 LaserFlow
Module, refer to the 2160 LaserFlow Module Installation and
Operation Guide.
To add an available (connected) LaserFlow Ex sensor and
activate in Flowlink, select the TIENet tab (Figure 4-1), then
highlight the appropriate LaserFlow module 2160 module, and
click the "Configure" button.
4-1
Advertisement
Table of Contents
