Replacing Fans 4, 5, And 6 - Christie HS 2K Series Service Manual

6. Remove the fan harnesses from the clips.
7. To separate the fan from the shielding, remove the six M3 screws with a Phillips #1 screwdriver.
8. Remove the corresponding fan from the rubber.
9. Replace the affected fan.
10. To re-install, follow these steps in reverse order.

Replacing fans 4, 5, and 6

The fans 4, 5 and 6 draw the air into the projector and provides exhaust cooling for the pump and
radiator module.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. To take out the thermal cooling fan module, remove the six screws with a Phillips #1
screwdriver.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
Ventilation and cooling
68