Replacing the DMD board
To remove the DMD board, complete the following steps.
1. Remove the light engine.
See
Replacing the light engine
2. Remove the color wheel.
See
Replacing the color wheel
3. Remove the combiner and radiator module.
See
Replacing the combiner and radiator module
4. Remove the DMD cold plate.
See
Replacing the DMD
5. To separate the DMD board from the DMD module, remove the four M3 screws with a Phillips
#1 screwdriver.
6. Remove the DMD board.
7. Remove the DMD mylar from the DMD board.
8. Replace the DMD board.
9. To re-install, follow these steps in reverse order.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 85.
on page 84.
on page 88.
Printed circuit boards and sensors
on page 89.
105