System Profiles - Dräger Infinity M540 Instructions For Use Manual

Operating concept

System profiles

System profiles are system-wide settings. System
profiles are divided into the following two
categories:
– Shared settings – these settings can be
exported and imported using a USB flash drive
(see page 490 for information).
– Install persist settings – these settings are not
affected by a patient discharge, software
upgrade,or by turning the Cockpit off and then
on again.
Setting
Brightness
Night time
External device
disconnected alarm
control
Keep Bed label
Transport alarm volume
Transport pulse tone
volume
Audio pause: Quiet mode
Minimum alarm volume
Audio off
All alarms off
Tone set
Delay
Duration
Speed
Waveform Selection
Waveform 1
Waveform 2
82
Shared and install persist settings
Screen layout settings (see page 445)
General alarm settings (see page 458)
M540 alarm settings (see page 466)
Tone and volume alarm settings (see page 458)
Recorder settings (see page 468)
Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Most system settings can be shared and are also
install persist settings. However, some settings are
install persist settings only which are identified in
the following table. For details on each setting, such
as available selections and detailed descriptions of
each setting, refer to the cross-referenced pages.
Install persist only settings
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X