Applying The Sensor - Dräger Infinity M540 Instructions For Use Manual

Acute care system

Hide thumbs Also See for Infinity M540:

Table of Contents

SpO2 and pulse rate with Nellcor OxiMax MCable

Applying the sensor

If you are using a reusable sensor, make sure it is

clean before applying it to the patient. Follow the

recommendations of the manufacturer.

Inspect the application site every two to three

hours to ensure skin quality and correct opti-

cal alignment. If the skin quality changes,

move the sensor to another site. Change the

application site at least every four hours.

Read the instructions provided with the sensor for

optimal application techniques and for safety in-

formation. Never use damaged sensors. Doing so

may compromise performance.

Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n

To apply the sensor

1 Select the size and type of sensor that is best

suited for your patient. Follow the

recommendations of the manufacturer.

2 Position the sensor correctly and attach it to

your patient.

3 Connect the sensor to the Nellcor OxiMax

After connecting the sensor, do the following if the

sensor-LED does not light up:

– Observe the monitor for any message and act

– Replace the sensor.

Show Quick Links

Table of Contents