Infineon Cypress CYW43353 Manual page 76

Table 27. Bluetooth Receiver RF Specifications (Cont.)
Parameter
30 MHz–1 GHz
1–12.75 GHz
851–894 MHz
925–960 MHz
1805–1880 MHz
1930–1990 MHz
2110–2170 MHz
1. The maximum value represents the actual Bluetooth specification required for Bluetooth qualification as defined in the version 4.1 specification.
2. Bluetooth reference level is taken at the 3 dB RX desense on each of the modulation schemes.
3. Interferer: 2380 MHz, BW=10 MHz; measured at 2480 MHz.
4. Interferer: 2355 MHz, BW=10 MHz; measured at 2480 MHz.
5. Interferer: 2560 MHz, BW=10 MHz; measured at 2480 MHz.
6. Interferer: 2360 MHz, BW=10 MHz; measured at 2402 MHz.
Table 28. Bluetooth Transmitter RF Specifications
Parameter
Note: The specifications in this table are measured at the chip port output unless otherwise specified.
Frequency range
Basic rate (GFSK) TX power at Bluetooth
QPSK TX Power at Bluetooth
8PSK TX Power at Bluetooth
Power control step
Note: Output power is with TCA and TSSI enabled.
–20 dBc BW
1.0 MHz < |M – N| < 1.5 MHz
1.5 MHz < |M – N| < 2.5 MHz
2
|M – N|  2.5 MHz
30 MHz to 1 GHz
1 GHz to 12.75 GHz
1.8 GHz to 1.9 GHz
5.15 GHz to 5.3 GHz
Spurious emissions
Document Number: 002-14949 Rev. *G
PRELIMINARY
Conditions
1
1
1
GFSK In-Band Spurious Emissions
–
EDR In-Band Spurious Emissions
M – N = the frequency range for which the
spurious emission is measured relative to
the transmit center frequency.
Out-of-Band Spurious Emissions
–
–
–
–
GPS Band Spurious Emissions
–
Minimum
Spurious Emissions
–
–
–
–
–
–
–
Conditions
General
Typical Maximum
–95 –62
–70 –47
–147 –
–147 –
–147 –
–147 –
–147 –
Minimum Typical Maximum
2402 – 2480
11.0 13.0 –
8.0 10.0 –
8.0 10.0 –
2 4 8
– 0.93 1
– –38 –26.0
– –31 –20.0
– –43 –40.0
– –
–36.0
– –
–30.0
– – –47.0
– – –47.0
– –103 –
CYW43353
Unit
dBm
dBm
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
Unit
MHz
dBm
dBm
dBm
dB
MHz
dBc
dBm
dBm
3, 4 dBm
dBm
b, 5, 6
dBm
dBm
dBm
Page 75 of 113