Odu Direct Mounting Type Antenna (Rfs Example) - NEC iPasolink 200 Manual

5-14
3 Rotate the transition hub 90 degrees until timing pin locates in timing concavity,
Transition Hub
Tighten six screws when transition hub is located. (Tightening torque is 5.0 N·m
±10%.

(3)) ODU Direct Mounting Type Antenna (RFS example)

Notes
Drain plug
1. Unscrew the 4 screws M3 at the refined
steel ring,
2. Hold the feed tightly at the waveguide,
3. Rotate carefully the feed 90 degrees,
4. Mount the feed to the refined steel ring
and lock the 4 screws M3.
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
Timing Pin
Vertical Polarized Application
)
1. The details are referred to the installation manual which is attached to
the antenna. The installation or removal of the antenna requires qualified
experienced personnel.
2. The antenna is set to V-polarization when shipped from the factory.
RFS SB1
Transition hub
Transition hub
Horizontally Polarized Application
Drain plug
1. Loosen the 4 screws M3,
2. Hold the feed tightly at the waveguide,
3. Rotate the casting plate carefully the
feed 90 degrees,
4. Lock the 4 screws M3.
ODU MOUNTING
RFS C-Mount
Installation