Direct Inward Dialing (Did) - NEC Aspire Series Networking Manual

Direct Inward Dialing (DID)

Direct Inward Dialing (DID)
Operation
Related Programs
Networking
An incoming DID call can be routed to an extension in a networked system.
For incoming DID calls, the system refers to Program 22-11 : DID Translation Number Conversion
to determine how to route the call. If the number is determined to be in the networked system, the
call will be routed to the proper system node.
It is possible to route to a Department Group pilot number at a remote system - the group can be set
to all ring mode. It is not possible to route a DID call to a ring group at the remote system.
The timer value is determined by the system data at the incoming trunk side if the incoming DID
call is transferred to a ring group due to the no-answer timer expiring.
Program Number
22-02 Incoming Service Type
22-09 DID Basic Data Setup
22-10 DID Conversion Area Setup
22-11 DID Conversion Table Data Setup
22-12 DID Transferred Destination Setup
Direct Inward Dialing (DID)
Title
Features
◆ 65