NEC iPasolink 200 Manual page 125

CABLE TERMINATION
(2) The washer and clamp nut are moved to the connector side, and it tightens. The
Notes
(3) The gap of the connector body and clamp nut is confirmed.
Tools
Note
Installation
Submission Prohibited
NEC Internal Use Only
tightening torque of the clamp nut is 8 to13 N·m.
Washer
16 mm
1. When inserting, do not put the chip which is braided wire inside the
central conductor and the connector body.
2. Do not turn connector body, turn clamp nut attachment.
* Gap: 2.1 ~ 2.45 mm (reference)
Gap is refenece, tightening must not become insufficient.
• spanner (16 mm)
• torque spanner (16 mm)
• clearance gauge, measure
Do not remove the connector body tightened up once.
When removing, it is reworked from procedure 1 or a cable is
exchanged.
Clamp nut
16 mm
8-13 N·m
* Check point
6-37
NWD-107460-02E