NEC iPasolink 200 Manual page 121

CABLE TERMINATION
2 Insertion of parts.
(1) The clamp are inserted in the cable.
(2) The braided wire is expanded a little. The cord tube is inserted between the
Tool
3 Center conductor, braided wire and insulator processing.
(1) After cord tube insertion, an aluminum tape and the insulator are cut along an
(2) Turning back the braided wire in the clamp, it cuts off the part which comes
(3) A central conductor is 6 to 7 mm from an end face.
(4) A point of a central conductor is chamfered.
Tools
Installation
Submission Prohibited
NEC Internal Use Only
aluminum tape and the braided wire.
Clamp
Braided wire
cord tube
• tweezers
end face.
out of the flange.
Cut it to become 6 to 7 mm when there are 7 mm or more.
Flange of clamp
cord tube
• cutter
• nipper
• file
Aluminum tape
End face
Chamfering
6 - 7 mm
6-33
NWD-107460-02E