NEC iPasolink 200 Manual page 124

6-36
Notes
4 Insertion of contact.
(1) The clamp is moved to the cord tube side.
(2) Cut off the braided wire which comes out of the flange.
(3) A spacer is inserted in a central conductor and contact is inserted.
Note There must be no gap between the contact, the spacer and the cord tube.
Refer to [common procedure] cable type A & type B for the next procedure.
[Common procedure] cable type A & type B
5 Connector assembly.
(1) Insert it until the cable assembly bumps inner connector.
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
1. Please note the position of the cord tube.
2. Do not damage the braided wire.
3. Do not damage the center conductor (burr etc.).
Clamp
Connector body
6-7 mm
Spacer
Contact
Gap "0"
CABLE TERMINATION
Installation