N-Pconnector Used For Odu If In/Out - NEC iPasolink 200 Manual

6-38
Procedure 6-8
1 First fit the tying metal, washer and gasket on the cable,
2 Strip back the cable sheath, taking care not to damage the braided shield, and fit
the clamp,
3 Fold back the braided shield (separating the strands of the braid) and trim it,
Note
4 Insert the ferrule,
5 Fit the bushing,
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only

N-PConnector used for ODU IF IN/OUT

(L-angle: N-LP-8DFB(B))
[Applicable cable: 8D-FB-E]
Cable
Clamp
9 mm
Pay attention not to damage the plait.
Ferrule
Bush
Washer
Gasket
CABLE TERMINATION
Tying Metal
Installation