NEC iPasolink 200 Manual page 112

6-24
Procedure 6-5
Outlines of parts
Cable jacket
Braided wire
Tools
1 Remove of Jacket of cable
Remove 6.5 mm of Jacket only, exposing braided wire.
Note
Tools
2 The braided wires processing-1
(1) Fold the braided wire around jacket.
(2) Remove 5.0 mm of insulator.
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
N-P Connector used for ODU IF IN/OUT
(Straight: 300PNM-C-NC)
[Applicable cable: 5D-FB-E]
Aluminum tape
Center conductor
insulator
• knife, cutter, nipper, tweezers, file, comb,
measure, clearance gauge, etc.
• spanner, torque spanner; 16 mm,15 mm
Do not damage the braided wire.
• knife
• cutter
• measure, etc.
Parts A
Connector body
6.5 mm
CABLE TERMINATION
Parts B (Clamp nut)
Installation