NEC iPasolink 200 Manual page 129

CABLE TERMINATION
Procedure 6-9
Outlines of parts
Cable jacket
Braided wire
Tools
1 Insertion of parts
The clamp nut, the washer and the gasket are inserted in the cable.
2 Remove of jacket of cable, insertion of parts,
(1) Remove 11 mm of jacket only.
(2) The clamp1 is inserted as shown.
Note
Tools
Installation
Submission Prohibited
NEC Internal Use Only
N-P Connector used for ODU IF IN/OUT
(Straight: N416(R0))
[Applicable cable: 8D-FB-E]
Aluminum tape
Center conductor
Insulator
Clamp nut
• knife, cutter, nipper, tweezers, file, measure,
clearance gauge, etc.
• spanner, torque spanner; 16 mm
Cable
Clamp nut
Do not damage the braided wire.
• knife
• cutter
• measure, etc.
Gasket
Washer
Clamp1
Washer
Gasket
11 mm
(Clamp1)
6-41
Connector body
NWD-107460-02E