Change Of Polarization Of Hybrid/Coupler - NEC iPasolink 200 Manual

ODU MOUNTING

Change of Polarization of Hybrid/Coupler

1 If you change the polarization from V to H, loosen two screws, rotate the
transition hub and put it to the Hybrid/Coupler.
Note
Transition
Hub
Hybrid/Coupler
V Polarization
2 Then fix it with the two screws that were loosened in step 1.
Installation
Submission Prohibited
NEC Internal Use Only
Note The hybrid/coupler is set to V-polarization when shipped from the
factory.
There are two types Hybrid/Coupler. One uses two pieces transition
hubs and another uses one piece.
Guide pin
Cross-recessed
head machine screw
M2.6 (2ea)
V Polarization
Cross-recessed
head machine screw
M2.6 (2ea)
V Polarization
Two Pieces Transition Hub Type
One Piece Transition Hub Type
5-23
H Polarization
H Polarization
NWD-107460-02E