Otto Bock 3R106 Instructions For Use Manual page 13

dere durch unsachgemäße Verwendung oder unerlaubte Veränderung des Produkts verursacht
werden, haftet der Hersteller nicht.
6.2 CE-Konformität
Das Produkt erfüllt die Anforderungen der Verordnung (EU) 2017/745 über Medizinprodukte. Die
CE-Konformitätserklärung kann auf der Website des Herstellers heruntergeladen werden.
Last update: 2020-07-03
• Please read this document carefully before using the product and observe the safety notices.
• Instruct the user in the safe use of the product.
• Please contact the manufacturer if you have questions about the product or in case of pro-
blems.
• Report each serious incident in connection with the product, in particular a worsening of the
state of health, to the manufacturer and to the relevant authority in your country.
• Please keep this document in a safe place.
1 Scope of delivery (Fig. 1)
1.1 4D3 Single Components Set for 3R106 
Consisting of: (6) 1 extension stop, (3) 4 truss head screws and (2) 4 two-hole nuts.
1.2 Minimum order quantity
(2) 502R1=M5×16 Two-hole Nut
(3) 501T1=M5×16 Truss Head Screw
1.3 Single components
(1) 4G70 Lamination Anchor
(5) 2R49 Tube Adapter
(8) 710H10=2×3 Adjustment Wrench
2 Description
2.1 Indications for use
Attention!
Reuse on another patient
Fall due to loss of functionality as well as damage to the product
• Only use the product for a single patient.
The 3R106 Polycentric Knee Joint is to be exclusively used for the prosthetic fitting of lower limb
amputees.
2.2 Field of application
Field of application according to the Ottobock MOBIS Mobility System:
Recommended for amputees with mobility grade 2 and 3 (restricted and
unrestricted outdoor walkers).
Approved for a patient weight of up to 100 kg / 220 lbs.
3R106, 3R106=KD, 3R106=ST, 3R106=HD
(4) 506G3=M8×10 Set Screw
(4a) 506G3=M8×12-V Set Screw
(7) 513D83=1.4×12.6×66 Compression Spring (strong)
(7a) 513D83=1.1×12.9×66 Compression Spring (weak)
English
Ottobock | 13