IBM Flex System x440 Compute Node Installation And Service Manual page 127

80070114-2201ffff Sensor [SensorElementName] has transitioned from normal to non-critical state.
Explanation: This message is for the use case when an implementation has detected a Sensor transitioned to
non-critical from normal.
May also be shown as 800701142201ffff or 0x800701142201ffff
Severity: Warning
Alert Category: Warning - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0520
SNMP Trap ID: 60
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
IMM message text. Please refer to the UEFI diagnostic code in the "UEFI diagnostic code" section of the Information
Center for the appropriate user response.
80070202-0701ffff Sensor Planar Fault has gone to Critical state from a less severe state.
Explanation: A failure has been detected in the system board.
May also be shown as 800702020701ffff or 0x800702020701ffff
Severity: Error
Alert Category: Critical - Voltage
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0522
SNMP Trap ID: 1
Automatically notify Support: No
User response: Complete the following steps:
1. Remove any recently installed components.
2. Try to power on the compute node.
v If the compute node successfully powers on, complete the following steps:
a. Check the ServerProven website to make sure that recently installed components are compatible with the
compute node.
b. Inspect the previously installed components for physical damage.
v If the compute node does not successfully power on or if this is not the first occurrence of this problem, replace
the system board.
8007020f-2201ffff Sensor TXT ACM Module has transitioned to critical from a less severe state.
Explanation: TXT ACM Module report it is above a normal state.
May also be shown as 8007020f2201ffff or 0x8007020f2201ffff
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0522
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
80070114-2201ffff • 8007020f-2201ffff
Chapter 6. Troubleshooting
115