IBM Flex System x440 Compute Node Installation And Service Manual page 456

I.1800D • I.2018002
I.1800D [I.1800D] A cache associativity mismatch has been detected for one or more processor packages.
Explanation: Processors have one or more cache levels with mismatched associativity
Severity: Info
User response: Complete the following steps:
1.
Verify that matching Processors are installed in the correct Processor sockets according to the service information
for this product.
2.
Check IBM support site for an applicable service bulletin or firmware update that applies to this Processor error.
3. (Trained Service technician only) Replace the system board.
I.1800E [I.1800E] A processor model mismatch has been detected for one or more processor packages.
Explanation: Processors have mismatched Model Number
Severity: Info
User response: Complete the following steps:
1. Verify that matching Processors are installed in the correct Processor sockets according to the service information
for this product.
2. Check IBM support site for an applicable service bulletin or firmware update that applies to this Processor error.
3. (Trained Service technician only) Replace the system board.
I.1800F [I.1800F] A processor family mismatch has been detected for one or more processor packages.
Explanation: Processors have mismatched Family
Severity: Info
User response: Complete the following steps:
1. Verify that matching Processors are installed in the correct Processor sockets according to the service information
for this product.
2. Check IBM support site for an applicable service bulletin or firmware update that applies to this Processor error.
3. (Trained Service technician only) Replace the system board.
I.18010 [I.18010] A processor stepping mismatch has been detected for one or more processor packages.
Explanation: Processors of the same model have mismatched Stepping ID
Severity: Info
User response: Complete the following steps:
1. Verify that matching Processors are installed in the correct Processor sockets according to the service information
for this product.
2. Check IBM support site for an applicable service bulletin or firmware update that applies to this Processor error.
3. (Trained Service technician only) Replace the system board.
I.2018002 [I.2018002] The device found at Bus % Device % Function % could not be configured due to
resource constraints. The Vendor ID for the device is % and the Device ID is %.
Explanation: OUT_OF_RESOURCES (PCI Option ROM)
Severity: Info
User response: Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or upgraded, reseat
adapter and any attached cables.
2. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update that applies to
this error. NOTE: It may be necessary to disable unused option ROMs from UEFI F1 setup or ASU or using
adapter manufacturer utilities so that adapter firmware can be updated.
444
IBM Flex System x440 Compute Node Types 7917 and 2584: Installation and Service Guide