IBM Flex System x440 Compute Node Installation And Service Manual page 545

v Hard disk drive backplane (see "Installing the hard disk drive backplane" on
page 521).
2. Install the bezel (see "Installing the bezel" on page 495).
What to do next
After you install the components on the system board of the new base assembly,
complete the following steps:
1. Install the cover onto the compute node (see "Installing the compute node
cover" on page 500 for instructions).
2. Install the compute node into the chassis (see "Installing a compute node in a
chassis" on page 490 for instructions).
3. Update the Universal Unique Identifier (UUID). Use the Advanced Settings
Utility to update the UUID in the UEFI-based compute node (see "Updating
the Universally Unique Identifier and DMI/SMBIOS data" on page 32).
4. Update the compute node with the latest firmware or restore the preexisting
firmware that the customer provides (see "Updating firmware and device
drivers" on page 23 for more information).
Removing the chassis bulkhead
Use this information to remove the chassis bulkhead.
Before you begin
Note: This procedure should be performed only by trained service technicians.
Before you remove the chassis bulkhead, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 487.
2. If the compute node is installed in an IBM Flex System chassis, remove it (see
"Removing a compute node from a chassis" on page 489 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
compute node with the bezel pointing toward you.
Procedure
To remove the chassis bulkhead, complete the following steps.
Screw
Screws
Chapter 7. Installing, removing, and replacing compute node components
Chassis bulkhead
Screw
533