Introduction; Purpose Of The Design Guide; Additional Resources; Document And Software Version - Danfoss VLT HVAC Drive FC 102 Design Manual

Introduction

1 Introduction

1.1 Purpose of the Design Guide

This design guide is intended for:
•
Project and systems engineers.
•
Design consultants.
•
Application and product specialists.
The design guide provides technical information to
understand the capabilities of the drive for integration into
motor control and monitoring systems.
®
VLT is a registered trademark.

1.2 Additional Resources

Other resources are available to understand advanced
drive operation, programming, and directives compliance.
•
The operating guide provides detailed information
for the installation and start-up of the drive.
•
The programming guide provides greater detail on
how to work with parameters and includes many
application examples.
•
®
The VLT Safe Torque Off Operating Guide
describes how to use Danfoss drives in functional
safety applications. This manual is supplied with
the drive when the Safe Torque Off option is
present.
•
®
The VLT Brake Resistor MCE 101 Design Guide
describes how to select the optimal brake resistor.
•
®
The VLT Advanced Harmonic Filters AHF 005/AHF
010 Design Guide describes harmonics, various
mitigation methods, and the operating principle
of the advanced harmonics filter. This guide also
describes how to select the correct advanced
harmonics filter for a particular application.
•
The Output Filters Design Guide explains why it is
necessary to use output filters for certain
applications, and how to select the optimal dU/dt
or sine-wave filter.
•
Optional equipment is available that can change
some of the information described in these
publications. Be sure to see the instructions
supplied with the options, for specific
requirements.
Supplementary publications and manuals are available
from Danfoss. See drives.danfoss.com/knowledge-center/
technical-documentation/ for listings.
MG16C302
Design Guide

1.3 Document and Software Version

This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the document version and the corresponding software
version.
Edition
MG16C3xx
Table 1.1 Document and Software Version

1.4 Conventions

•
•
•
•
•
Danfoss A/S © 11/2017 All rights reserved.
Remarks
Removed D1h–D8h content and
implemented new structure.
Numbered lists indicate procedures.
Bullet lists indicate other information and
description of illustrations.
Italicized text indicates:
- Cross-reference.
- Link.
- Footnote.
- Parameter name, parameter group
name, parameter option.
All dimensions in drawings are in mm (in).
An asterisk (*) indicates a default setting of a
parameter.
1 1
Software
version
5.11
5