Configuring Basic Parameters Of Base Station; Table 3-1: Basic Npu Parameters - Nera WILINK I System Manual

Chapter 3 - Commissioning
3.1 Configuring Basic Parameters of Base
Station
After completing the installation process, as described in the preceding chapter,
some basic parameters must be configured using the Monitor application via the
MON port of the NPU. These parameters are necessary to enable remote
management using SNMP or Telnet.
The basic parameters are listed in Table 3-1. Refer to Chapter 4 – Operation and
Administration, for detailed information on the applicable parameters.
Management Option
MGMT port
DATA port
Authorized Managers
(per manager)
The following are the guidelines for configuring the basic parameters:
All parameters of both ports should be configured. Otherwise, default values
shall be used.
If OOB management via a router connected to the Management port is used,
the parameters should be configured to ensure different subnets for the Data
port, the Management port (local OOB management) and the Management
50

Table 3-1: Basic NPU Parameters

Parameters
Management Port IP address
Management Port Subnet Mask
Management Port Gateway
Management Port Destination Subnet
Management Port Destination Subnet Mask
Management Port Management Traffic Enable/Disable
Data Port IP address
Data Port Subnet Mask
Data Port Gateway
Data Port Management VLAN ID
Data Port Management Traffic Enable/Disable
Data Port Speed
IP Address
Send Traps
Read Community
Write Community
WILINK I MODULAR BASE STATION SYSTEM MANUAL