Nera WILINK I System Manual page 77

Chapter 4 - Operation and Administration
Updated ATPC parameters are applied for each AU after resetting the AU (or after
resetting the NPU, which causes reset of all AUs).
The ATPC menu enables viewing/updating the following parameters for all AUs:
4.4.2.3.1 ATPC Enable/Disable
The ATPC Enable/Disable parameter controls whether the ATPC algorithm
should be used to determine current optimal transmit level for each SU served by
the Base Station.
The default is Enable.
NOTE
The ATPC algorithm should always be enabled. The option to disable it is available to enable using
a fixed rate to support certain tests. After each reset, the Base Station boots with the ATPC
enabled, disregarding its status before the device was reset.
4.4.2.3.2 Optimal Uplink RSSI
The Optimal Uplink RSSI sets the target level at which all transmissions should
be received by the AU-ODUs for optimal performance.
The range is –103 to –60 (dBm).
The default is –69 dBm.
4.4.2.4 Cell Parameters
The Cell parameters provide a unique identifier for the Base Station, and they are
common to all AUs in the Base Station. Updated Cell parameters are applied for
each AU after resetting the AU (or after resetting the NPU, which causes reset of
all AUs). The Cell menu enables viewing/updating the following parameters:
4.4.2.4.1 Operator ID
A unique identifier of the network. The same Operator ID must be defined for all
Base Stations/Micro Base Stations in the network, and it should not be used by
any Base Station/Micro Base Station belonging to another network in the same
area.
The Operator ID consists of 3 groups of up to three digits each, where the range
for each group is 0 to 255.
The default Operator ID is 186.190.0.
Changes in the value configured for the Operator ID are applied only after reset.
4.4.2.4.2 Cell ID
A unique identifier of the Base Station. The same Cell ID should not be used by
any other Base Station/Micro Base Station belonging to the network.
66
WILINK I MODULAR BASE STATION SYSTEM MANUAL