Nera WILINK I System Manual page 109

Chapter 4 - Operation and Administration
4.8.4.2 Unit Control
The AU Unit Control menu enables resetting the AU and managing the SW
versions of the module.
The Unit Control menu includes the following options:
Reset
Set Factory Defaults
SW Version Control
4.8.4.2.1 Reset Unit
Select this option to reset the unit. To avoid unintentional reset, you will be
prompted to confirm the reset request. Changes to some of the configurable
parameters are applied only after reset. Refer to Section
which parameters are changeable in run time and which changes are applied
only after reset.
4.8.4.2.2 Set Factory Defaults
Select this option to set the AU parameters to their factory default values. Refer to
Section
The parameters will revert to their default values after the next reset.
4.8.4.2.3 SW Versions Control
The AU can contain two SW versions:
Main: Each time the AU resets it will reboot using the version defined as
Main.
Shadow: Normally, the Shadow version is the backup version. Each time a
new SW File is downloaded to the AU, it will be stored as a Shadow version,
replacing the previous Shadow Version.
The process of upgrading to a new SW version is controlled by the NPU, and is
performed using one of the AU SW files installed in the NPU. If the specified AU
SW file does not exist in the AU, it will be downloaded to the AU and the
requested operation will be executed, as described below. If it already exists in
the AU, then actual loading is not necessary.
The following options are available in the SW Version Control menu:
4.8.4.2.3.1 Show Versions
Select this option to view the following information:
98
4.11 for information on the factory default values of these parameters.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
4.11 for information on