Nera WILINK I System Manual page 169

Chapter 4 - Operation and Administration
4.10.5 Defining Services
The process of defining completely new Services should be done "from bottom
up", as each entity in the process is defined using one or more "lower level"
entities.
To define a new Service "from scratch":
1 Define the QoS profiles that should be available for the required Priority
Classifiers (Uplink/Downlink QoS Profiles) and for the required Forwarding
Rules (Multicast QoS Profile).
2 Define the Priority Classifiers that should be available for the required Service
Profiles. All QoS Profiles required for the Uplink/Downlink QoS profiles list
must be defined in advance.
3 Define the Forwarding Rules that should be available for the required Service
Profiles. The QoS Profiles required for the Multicast QoS Profile parameter
must be defined in advance.
4 Define the Service Profiles that should be available for the required Services.
All required Priority Classifiers and Forwarding Rules must be defined in
advance.
5 Define the relevant Subscribers.
6 Verify that all applicable SUs are defined.
7 Use existing Subscriber Name, SU MAC Address and Service Profile Name to
define the required Service.
Once there are various QoS Profiles, Priority Classifiers, Forwarding Rules,
Service Profiles, Subscribers and SUs in the database, you can skip one or more
of the steps 1 to 6.
4.10.6 Pre-configured Profiles
At manufacturing stage, each NPU is configured with a set of pre-configured
Profiles. Certain parameters of these Profiles may be modified to reflect specific
implementation requirements. When the software version is upgraded, these pre-
configured Profiles will not be installed again in the NPU. This is to prevent
configuration problems from occurring if the modified Profiles differ from the
factory loaded Profiles.
Note that upon resetting to NPU to its default configuration (Set Factory
Defaults), pre-configured Profiles that were modified are not affected.
The pre-configured Service Profiles are:
158
WILINK I MODULAR BASE STATION SYSTEM MANUAL