Nera WILINK I System Manual page 127

Chapter 4 - Operation and Administration
4.9.6.2 Unit Control
The SU Unit Control menu enables defining the SU's status, resetting the SU and
managing the SW versions of the unit.
The Unit Control menu includes the following options:
Status
Reset
Set Factory Defaults
SW Version Control
4.9.6.2.1 SU Status
The SU Status parameter enables defining the status of the SU, which determines
the services it can receive.
The available options are:
1 – Permanent
2 – Temporary
NOTE
An SU that is defined as Temporary will be deleted from the database when it is disconnected.
4.9.6.2.2 Reset Unit
Select this option to reset the unit. To avoid unintentional reset, you will be
prompted to confirm the reset request. Changes to some of the configurable
parameters are applied only after reset. Refer to Section
which parameters are changeable in run time and which changes are applied
only after reset.
4.9.6.2.3 Set Factory Defaults
Select this option to set the SU parameters to their factory default values. Refer to
Section
The parameters will revert to their default values after the next reset.
4.9.6.2.4 SW Versions Control (only for Permanent SUs)
The SU can contain two SW versions:
Main: Each time the SU resets it will reboot using the version defined as
Main.
116
4.11 for information on the factory default values of these parameters.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
4.11 for information on