Nera WILINK I System Manual page 131

Chapter 4 - Operation and Administration
4.9.6.3.2 MAC Parameters
The SU MAC menu enables viewing/updating the following parameters:
4.9.6.3.2.1 Base Station ID
The Base Station ID is the identifier of the AU/µBST to which the SU can
connect. An SU can be authenticated by an AU/µBST only if the Base Station ID
and Base Station ID Mask configured in the SU match the Base Station ID
configured for the AU/µBST. A change in the Base Station ID and Base Station ID
Mask will take effect only after resetting the SU.
The Base Station ID consists of six groups of up to three digits each, where the
range for each group is 0 to 255. The first three groups define the Operator ID,
the next two groups define the Cell ID and the sixth group defines the Sector (AU)
ID.
A change in the Base Station ID is applied only after reset.
4.9.6.3.2.2 Base Station ID Mask
The Base Station ID Mask, together with the Base station ID define the
AU(s)/µBST(s) that can synchronize with the SU.
The Base Station ID Mask consists of 6 groups of up to 3 digits each, where the
range of each group is 0 to 255. The first 3 groups form the mask for the
Operator ID. The next 2 groups form the mask for the Cell ID, and the last group
forms the mask for the Sector ID.
A change in the Base Station ID Mask is applied only after reset.
4.9.6.3.3 Phy Parameters
The SU Phy menu enables viewing/updating the following parameters:
4.9.6.3.3.1 Bandwidth (MHz)
The frequency bandwidth used by the radio. A change in the Bandwidth
parameter will take effect only after resetting the SU.
The available options are:
1 – 1.75 MHz
2 – 3.5 MHz
NOTE
In the current version the PRO CPE supports only a Bandwidth of 3.5 MHz.
120
WILINK I MODULAR BASE STATION SYSTEM MANUAL