Nera WILINK I System Manual page 102

4.7.3 Add
Select this option to define a new ODU. For details on the configurable
parameters refer to Section 4.7.4.
4.7.4 ODU Parameters
4.7.4.1 ODU ID
A number used to identify the ODU. The ODU ID is configurable only when
adding a new ODU.
The available values range from 1 to 24.
4.7.4.2 Associated Radio Cluster
The ID of the associated Radio Cluster.
The available values range from 1 to 6. The value must be that of an already
defined Radio Cluster.
4.7.4.3 Configured ODU Frequency Band
The Configured ODU Frequency Band will be modified through the use of
Frequency Bands Configuration file (see Section 4.7.5).
The available values are the list numbers from the displayed list of available
Frequency Bands.
The Configured ODU Frequency Band can be updated only if the ODU is not
associated with any AU Channel, or if the Admin Status of the associated AU
Channel is Disabled.
Compatibility between the Configured ODU Frequency Band and its actual band
is verified by the AU upon attempting to associate the ODU with a Channel. If the
Configured ODU Frequency Band differs from the actual band supported by the
ODU, a mismatch trap will be sent by the AU upon attempting to associate it with
a Channel and the association will be rejected.
4.7.4.4 Tx Power
The Tx Power parameter defines the power level of the transmitted signal at the
antenna port of the ODU.
The range is from 13 to 28 dBm (18 to 28 dBm in 3.6 GHz units) using a 0.25
dBm resolution.
The default is 28 dBm.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
ODU Menu
91