Nera WILINK I System Manual page 72

The first selectable item in most menus is the Show option, enabling to view
the current configuration of the applicable parameters. For some menus some
additional status information is displayed.
For certain parameters, an updated value is applied only after reset or after
entering a specific command. In these parameters, the configured value may
differ from the actual value. If the configured value differs from the actual
value both values will be displayed, where the first one is the configured value
and the second is the actual value. For example: "Bandwidth (MHz): 1.75, 3.5"
means that the configured bandwidth, to be applied after the next reset, is
1.75 MHz, and the current actual bandwidth is 3.5 MHz.
For certain parameters the actual values may not be available (such as when
pre-configuring an AU that is not yet installed). For these parameters a value
of NA (Not Available) will be displayed.
The Update/Add options will display all applicable parameters line by line,
allowing to conveniently edit all of them. The current value is displayed for
each parameter. To keep the current value - press Enter. To change it - enter
a new value and press Enter.
Press the Tab key for context sensitive help text (where applicable).
If an erroneous value was entered - the reason of the error or help text will be
displayed, and the parameter entry text will be displayed again.
Many menus include a Select By option, enabling to get a sub-menu for a
selected entity according to the selection criteria.
If the Monitor program is not used for 10 minutes, the session will be
automatically terminated.
Select the Exit option in the Main menu to exit the program and terminate the
session.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
The Monitor Program
61