Nera WILINK I System Manual page 88

Profiles: profiles.res
Profiles and Services: profiles_srvcs.res
Filtering: filtering.res
Traps Configuration: traps_config.res
The file is encrypted and cannot be edited. However, it can be downloaded to
other NPU(s) using a DOS based TFTP Client application with the command:
tftp -i <Port IP address> put <file name>.
The target NPU will decrypt the backup file, extract all the configuration files and
databases and will store them, replacing existing files/databases. The NPU
should be reset to apply the downloaded configuration.
NOTE
To avoid loss of connectivity behind a router, the basic IP parameters of the MGMT and DATA
ports (IP Address, Subnet Mask, Default Gateway) are not changed when loading a Full backup file
to the NPU. The values of these parameters configured in the target NPU before the loading
process, are maintained.
4.5.2.6 Monitor Inactivity Timeout
The Monitor Inactivity Timeout parameter determines the amount of inactive time
following which the unit automatically exits the Monitor program.
The time out duration can range from 0 to 60 minutes. 0 means no inactivity
timeout.
The default value is 10 minutes.
4.5.3 Configuration
The NPU Configuration menu enables viewing and updating parameters that
define the functionality of the MGMT and DATA ports, the properties of
authorized management stations and bridging functionality.
The following are the guidelines for configuring these parameters:
All IP parameters of both ports should be configured. Otherwise, default
values shall be used.
The Destination Subnet parameters of the MGMT port enable defining an
additional subnet of stations that can manage the device when connected via
a router to the MGMT port. If OOB management via a router connected to the
MGMT port is used, the parameters should be configured to ensure different
subnets for the Data port, the Management port and the Management Port
Destination Subnet.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
NPU Menu
77