Table of Contents
Advertisement
Chapter 3 - Commissioning
3.1
Configuring Basic Parameters of Base
Station
After completing the installation process, as described in the preceding chapter,
some basic parameters must be configured using the Monitor application via the
MON port of the NPU. These parameters are necessary to enable remote
management using SNMP or Telnet.
The basic parameters are listed in
information on the applicable parameters.
Management Option
MGMT port
DATA port
Authorized Managers
(per manager)
The following are the guidelines for configuring the basic parameters:
56
Table
Table 3-1: Basic NPU Parameters
Parameters
¢
Management Port IP address
¢
Management Port Subnet Mask
¢
Management Port Gateway
¢
Management Port Destination Subnet
¢
Management Port Destination Subnet Mask
¢
Management Port Management Traffic Enable/Disable
¢
Data Port IP address
¢
Data Port Subnet Mask
¢
Data Port Gateway
¢
Data Port Management VLAN ID
¢
Data Port Management Traffic Enable/Disable
¢
Data Port Speed
¢
IP Address
¢
Send Traps
¢
Read Community
¢
Write Community
3-1. Refer to
Chapter 4
for detailed
Commissioning
Advertisement
Table of Contents
