Nera WILINK I System Manual page 94

4.5.3.3.3.4 Write Community
The SNMP Write Community to be used by the Authorized Manager. A null Write
Community means that the Authorized Manager has Read-only access rights.
Valid Community strings: Up to 23 printable characters, case sensitive.
4.5.3.4 Bridge
The Bridge submenu enables configuring the Bridge Aging Time parameter,
setting the aging time for all addresses in the Forwarding Data Base.
The available values are from 1 to 1440 minutes, or null for no aging.
The default is 10 minutes.
4.5.3.5 Voice
The Voice submenu enables configuring the DRAP TTL Retries parameter. This
parameter sets the limit of TTL retries for gateways that support the DRAP
protocol before concluding that the gateway is no longer active and removing it
from the database. The TTL retry time (the maximum time between two
consecutive Allocation Requests) is 255 seconds.
The range is from 1 to 100.
The default is 4.
NOTE
During SW download to a gateway, which may take up to almost 15 minutes under worst
conditions, the DRAP protocol is not active. If the gateway is removed from the database before
SW download is completed, the download process will fail. During SW download, the DRAP TTL
Retries parameter should be set to its default value of 4 (equivalent to 17 minutes).
4.5.4 Performance Monitoring
The Performance Monitoring option enables to view and reset the NPU Ethernet
Ports counters. The Performance Monitoring submenu includes the following
options:
Data Port
Management Port
All counters
4.5.4.1 Data Port Counters
The Data Port option enables viewing or resetting the Data (DATA) port counters.
The information displayed for each counter is the accumulated number since the
WILINK I MODULAR BASE STATION SYSTEM MANUAL
NPU Menu
83