Table 4-2: Default Passwords - Nera WILINK I System Manual

Chapter 4 - Operation and Administration
Access Level
Administrator
Installer
Monitor
4.5.2.2 Reset Unit
Select this option to reset the NPU. To avoid unintentional reset, you will be
prompted to confirm the reset request. Changes to some of the configurable
parameters are applied only after reset. Refer to Section
which parameters are changeable in run time and which changes are applied
only after reset.
4.5.2.3 Set Factory Defaults
Select this option to set the Base Station and NPU parameters (excluding the
access Passwords) to their factory default values. Refer to Section
information on the factory default values of these parameters. The parameters
will revert to their default values after the next reset.
NOTE
Setting the parameters of the NPU to their default values will disable remote management of the
Base Station since this affects the IP and Ethernet parameters and will delete all Authorized
Managers.
4.5.2.4 SW Version Control
The NPU can contain two SW versions:
Main: Each time the NPU resets it will reboot using the version defined as
Main.
Shadow: Normally the Shadow version is the backup version. Each time a
new SW File is downloaded to the NPU, it will be stored as a Shadow version,
replacing the previous Shadow Version.
The typical process of upgrading to a new SW version includes the following
steps:
1 Download the new SW File to the NPU. It will be stored as the Shadow
version.
2 Reset and run the module from its Shadow version. Note that at this stage,
after reset the unit will reboot from its previous Main version.
74

Table 4-2: Default Passwords

Default Password
admin
installer
monitor
WILINK I MODULAR BASE STATION SYSTEM MANUAL
4.11 for information on
4.11 for