Nera WILINK I System Manual page 130

Ethernet Port
Installer Password
Bridging Parameters
4.9.6.3.1 Registration Parameters
The SU Registration Parameters option in the NPU Monitor enables viewing the
SU's Registration parameters and updating the SU Name parameter. Other
Registration parameters can be configured only locally at the SU (via the Ethernet
port).
4.9.6.3.1.1 SU Name
The SU Name is typically configured locally in the SU (Common Name).
The default SU Name given to a new SU during the definition process (see Section
4.9.7) is SU@<SU's MAC Address>. When an SU is registered, it receives services
based on its MAC address, and the default SU Name is replaced by the name
configured in the SU (Common Name).
Under normal conditions, the SU Name should be changed only upon identifying
an SU with an SU Name that is identical to that of a previously registered SU. In
this case, the new SU will be registered (to enable management), but will not
receive any services. Its name in the NPU database will be changed to
SU@<SU's MAC Address>. The system administrator will be informed of the
problem through the Fault Status parameter in any of the relevant Show menus
(Fault Status 2) and through a trap message (rbSuDuplicateName trap). If the
administrator decides that the SU is legitimate and should receive services, a new
SU Name must be configured. The SU will receive services only after configuring
it with a unique SU Name.
A new SU Name can be configured also for a temporary SU.
The SU Name comprises a string of up to 32 printable characters.
A change in the SU Name parameter takes effect only after reset.
4.9.6.3.1.2 Organization Name
The Organization Name configured in the SU.
4.9.6.3.1.3 Address
The Address configured in the SU.
4.9.6.3.1.4 Country
The Country name configured in the SU.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
SU Menu
119