Nera WILINK I System Manual page 132

4.9.6.3.3.2 Uplink (Tx) Frequency (MHz)
The frequency used in the uplink (from SU to AU). A change in the Uplink
Frequency parameter will take effect only after resetting the SU.
The available values depend on the Bandwidth and on the available Frequency
Bands in the Frequency Bands Group supported by the AU (see Section 4.7.5).
4.9.6.3.4 Multirate and ATPC Parameters
The Multirate and ATPC mechanism are controlled by the AU (except to the
option to temporarily control them locally at the SU for testing purposes). The
Show Multirate and ATPC Status and Parameters option enables viewing the
current status of the applicable parameters. The Set Rates option can be used to
set uplink and downlink rates per SU only when Multirate is disabled.
4.9.6.3.4.1 Show
The Show option enables viewing the current status of the following parameters:
Uplink RSSI (dBm)
Uplink SNR (dB)
Uplink Rate
Downlink RSSI (dBm)
Downlink SNR (dB)
Downlink Rate
ATPC Support
Tx Power (dBm)
4.9.6.3.4.2 Set Rates
The Set Rates option is available only when the Multirate algorithm is disabled in
the AU (see Section 4.8.4.3.4), allowing to set the Uplink Current Rate and the
Downlink Current Rate to any of the values listed in Table 4-5.
The defaults are the last rates used by the Multirate algorithm before it was
disabled. For SUs that join the cell when the Multirate algorithm is disabled, the
defaults are the applicable Basic Rates.
WILINK I MODULAR BASE STATION SYSTEM MANUAL
SU Menu
121