Removing The Perc Card From The Internal Perc Riser - Dell EMC PowerEdge R740xd2 Installation And Service Manual

Figure 30. Installing internal PERC riser
Next steps
1 Connect the cables to the backplane and then route the cables to the cable guiding latch and close the latch.
2 If removed, install the rear drive
3 Install the air shroud.
4 Install the system cover.
5 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
6 Open the drive bays, install
7 Install the power supply
8 Follow the procedure listed in

Removing the PERC card from the internal PERC riser

Prerequisites
1 Follow the safety guidelines listed in
2 Power off the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Open the drive bays, remove
5 Remove the power supply
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 Remove the system cover.
8 Remove the air shroud.
9 If installed, remove the rear drive
10 Remove the internal PERC
58 Installing and removing system components
cage.
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
riser.
system.