Mini Perc Card Battery; Removing The Mini Perc Card Battery - Dell EMC PowerEdge XE7420 Installation And Service Manual

Figure 35. Installing the mini PERC module
Next steps
1. Install the air shroud.
2. Install the sled.
3. Follow the procedure listed in

Mini PERC card battery

Removing the mini PERC card battery

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the sled.
4. remove the air shroud.
5. Remove the PCIe card module.
6. Remove the mini PERC card module
Steps
1. Loosen the hook on the air shroud.
2. Push the retention clip down and lift the mini PERC battery out of the air shroud.
68 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
and disconnect the cable from the mini PERC card module.
system.
system.