Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
DIMM
O REPLACE A
1 Shut down, and then open the ColorPASS (see pages
To access the DIMMs, you must remove the left panel.
2 To release a DIMM, push outward on the levers on each side of the DIMM.
Lever
Releasing a DIMM
F
25:
IGURE
3 Pull the DIMM straight out of the socket.
4 To replace a DIMM, insert the DIMM straight into the socket and close the levers at each side
to lock it into place.
N
:
The socket is keyed so that the DIMM fits only one way. (See the notches in the
OTE
preceding figure.)
Make sure that the entire length of the DIMM (ends and center) is fully seated in the socket
and that the levers close securely around the ends of the DIMM.
5 If you installed a new DIMM, clear the CMOS as follows:
You must clear the CMOS after installing a new DIMM to ensure compatibility
N
:
OTE
between the new component and the previous settings stored in the BIOS. Make sure that the
power cable is removed from the power outlet before clearing the CMOS.
• Remove the battery (see
• Wait two minutes to allow the motherboard electrical components to fully discharge.
• Reinstall the battery.
6 If you installed a new DIMM and cleared the CMOS, make sure to reset the time and date in
Setup (see Configuration and Setup, which is part of the user documentation set).
7 Reassemble the ColorPASS and verify its functionality (see
48
DIMM
Socket notch
page
82).
and 51).
Lever
DIMM notch
page
103).
77
Advertisement
Table of Contents
