Table of Contents
Advertisement
T
O CONNECT POWER
1 Connect the recessed end of the ColorPASS power cable to the power connector on the back of
the ColorPASS (see
2 Connect the other end of the ColorPASS power cable to a power outlet.
T
O CONNECT TO THE COPIER
1 Make sure that the ColorPASS and the copier are powered off.
2 Connect one end of the copier interface cable to the ColorPASS.
3 Connect the other end of the copier interface cable to the copier.
Tighten the screws completely on both ends of the cable.
4 Connect the scan crossover cable to the scan ports on the ColorPASS and the copier.
N
included with the ColorPASS look similar, but are not interchangeable. Make sure that you
connect the scan crossover cable to the lower RJ-45 port on the ColorPASS back panel (see
Figure 5 on page 28
Align cables side by
side and examine wires.
F
I
NSTALLATION
Figure 5 on page
:
The straight-through network cable at the customer site and the scan crossover cable
OTE
and
Figure
1
2 3
4
=
1
6:
Straight-through and crossover Ethernet cables
IGURE
28).
6).
Straight-through cable:
wire arrangements are
identical on both connectors
2 3
4
Crossover cable:
wire arrangements
are different
29
Advertisement
Table of Contents
