Table of Contents
Advertisement
S
ERVICE
5 To replace the top panel, route the UIB cable through the hole in the top of the chassis and
attach it to motherboard connector USB3.
6 Position the top panel on the top of the chassis.
Place the hooks on the underside of the panel into the slots in the top of the chassis, and then
slide the top panel toward the back of the chassis to engage the hooks.
N
:
You may need to tap the front edge of the panel toward the back of the chassis to
OTE
engage the panel completely.
7 Replace the plug on the top panel.
Correctly align the plug, and then place it into the receptacle on the top panel. Secure the
plug by replacing the locking bolt through the cutout in the left side of the top panel.
Removing and replacing boards
This section includes procedures for removing and replacing the following boards:
• Copier interface
• User interface board
• Motherboard
The ColorPASS is shipped from the factory with a standard board configuration, as shown in
Figure 11 on page
that accompanies the particular option kit.
Copier interface board
The copier interface board provides the print interface between the ColorPASS and the
copier. It is installed in motherboard connector PCI-E6. The copier interface processes the
image data and sends it to the copier through the copier interface cable available on the
ColorPASS back panel.
F
17:
IGURE
P
ROCEDURES
45. If optional components have been installed, see the documentation
Diagram of the copier interface
To motherboard connector PCI-E6
55
Advertisement
Table of Contents
