Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
3 Secure cables as necessary with any plastic cable clamp that you may have removed earlier.
4 Replace the copier interface in motherboard connector PCI-E6 (see
Make sure to install the board mounting bracket screw to secure the board to the chassis. Press
down firmly on the top of the board as you insert the screw.
N
:
Make sure that unused back panel slots are covered with slot covers. Uncovered slots
OTE
reduce air flow and may cause the ColorPASS to overheat.
5 If you reinstalled the old motherboard, reassemble the ColorPASS and verify its functionality
(see
page
103).
6 If you replaced the motherboard with a new motherboard, clear the CMOS as follows:
N
:
You must clear the CMOS after installing a new motherboard to ensure compatibility
OTE
between the new component and the previous settings stored in the BIOS. Make sure that the
power cable is removed from the power outlet before clearing the CMOS.
• Remove the battery (see
• Wait two minutes to allow the motherboard electrical components to fully discharge.
• Reinstall the battery.
7 If you replaced the motherboard with a new motherboard and cleared the CMOS, do the
following:
• Reassemble the ColorPASS (see
• Reset the time and date in Setup (see Configuration and Setup, which is part of the user
documentation set).
• Proceed to
"Replacing parts on the motherboard" on page
page
82).
page
103).
Figure 21 on page
61).
76.
68
Advertisement
Table of Contents
