Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
Verifying new motherboard installation and transferring options
After you install a new motherboard and reassemble the system, do the following:
• Verify all functionality by using the one-time use dongle to enter Service Mode. (Service
Mode is not indicated on the monitor or LCD, but is entered once you power on with a
new motherboard installed and the one-time use dongle installed on a USB port.)
Service Mode is a temporary state that allows you to make sure that the motherboard
solves the problem that you are troubleshooting. Service Mode is exited automatically
when you expend the one-time use dongle to transfer options to the new motherboard (see
"Transferring options to the new motherboard" on page
Features of SeeQuence Impose and Compose are not available while in Service Mode.
N
:
OTE
• If the new motherboard solves the problem that you are troubleshooting, use the
one-time use dongle and the Fiery Options Utility DVD to transfer options to the new
motherboard.
If you determine while in Service Mode that the problem you are troubleshooting was not
fixed by installing a new motherboard, do not expend the one-time use dongle to transfer
options to the new motherboard (described below), do not install system software, and do
not replace the hard disk drive. Reinstall the old motherboard and return the new
motherboard and the unused one-time use dongle to inventory. You may then perform
additional service and troubleshooting procedures.
Transferring options (for example, Fiery Graphic Arts, Premium Edition, if applicable)
expends the one-time use dongle. For details, see
motherboard" on page
Do not transfer options to the new motherboard prematurely. Do so only after you verify the
new motherboard in Service Mode. Remember that once options are transferred to the new
motherboard using the one-time use dongle, the motherboard is customized and cannot be
used in another system.
71.
71).
"Transferring options to the new
69
Advertisement
Table of Contents
