Table of Contents
Advertisement
I
NSTALLATION
T
O CONNECT TO THE NETWORK
1 Make sure that the ColorPASS is powered off.
2 Connect the network cable to the upper RJ-45 network port on the back of the ColorPASS (see
Figure 5 on page
The ColorPASS provides twisted pair connectivity to an Ethernet network. When the
network cable is connected, the Ethernet interface automatically detects the speed of the
network environment. Depending on your network speed, the following unshielded twisted
pair (UTP) network cables are supported:
• 10BaseT: Category 3 or higher
• 100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)
• 1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)
After power on, the network administrator should perform Network Setup, verify the network
connection, verify that the ColorPASS appears in the list of printers, and then print a few test
documents from a networked computer that will use the ColorPASS. For more information,
see Configuration and Setup, which is part of the user documentation set.
N
:
The straight-through network cable at the customer site and the scan crossover cable
OTE
included with the ColorPASS look similar, but are not interchangeable. Make sure that you
connect the network cable to the upper RJ-45 port on the ColorPASS back panel (see
Figure 5 on page 28
28).
and
Figure 6 on page
29).
30
Advertisement
Table of Contents
