Table of Contents
Advertisement
S
ERVICE
Fan
A fan mounted inside the ColorPASS chassis draws air into the ColorPASS to cool
components. The fan runs continuously when the system is on. You should hear the fan start
as soon as you power on the ColorPASS. If you do not hear the fan, there may be a faulty
power connection (see
The following procedures describe how to remove and replace the fan.
T
O REMOVE THE FAN
1 Shut down, and then open the ColorPASS (see pages
To access the fan, you must remove the left panel.
2 Remove the fan cable from motherboard connector FAN 4.
3 Release the fan from the fan bracket by bending the hooks on the bracket.
Hook
(1 of 2)
F
29:
IGURE
4 Remove the fan from the chassis.
T
O REPLACE THE FAN
1 Align the fan.
An arrow on the side of the fan indicates the airflow direction. Make sure that the fan is
positioned so that the arrow points inside the ColorPASS and the fan cable extends
downward toward the motherboard (see
2 Press the fan into the bracket until it clicks into place.
Make sure that the hooks on the bracket close over the edge of the fan.
3 Connect the fan cable to motherboard connector FAN 4.
4 Reassemble the ColorPASS and verify its functionality (see
P
ROCEDURES
page
48).
Air flow direction
Removing the fan
48
and 51).
Fan bracket
Fan
Fan cable extending downward
Figure
29).
page
103).
85
Advertisement
Table of Contents
